Drawing Borad with LIght

Product Measurements:

Drawing Board Dimensions: 27.8cm x 20.7cm

Pen: 13.5cm                                                                                                                                                                                                                                                                                                                                                                                                          Description:

The kit consists of a PVC-based pointer. (The tablet is not electrical)

The thickness of the tablet is 5 mm.

On the surface of the tablet, a photogenic cover is applied under a transparent protection to protect the product from erasure.

Also in the set there is a marker-flashlight, with the help of which the process of drawing on the tablet occurs.

Principle of operation and application:

Our product is designed for drawing in the dark. The photogenic cover of the plate accumulates lights from any light source and glows itself in the dark, then gradually the glow passes. At the end of the flashlight marker is a diode that gives a glow. The included flashlight marker should be directed to the surface of the tablet, which is covered with a luminous film and you can draw any figures, patterns and other pictures on this tablet arbitrarily.

The drawing cannot be erased. It will gradually disappear in 30 to 40 minutes, but each time a new line is brighter than the previous one, the drawing on the tablet can be prolonged. The surface of the tablet is not abrasion-resistant and is intended for frequent and reusable use.

Drawing skills:

Take out the tablet. Touch the controller on the tablet while holding down the button on the marker and start drawing. The vertical position of the controller allows you to draw (Figure 1.2).

Adjust the distance from the controller to the surface of the tablet. The closer the controller to the tablet is, the sharper and brighter the line is. With the distance of the controller, the light line is scattered

(Figure 1.3).

The controller is at an angle to the tablet. Press the button and draw a line to achieve a blurred edge effect.                                                                                                                                                                                              Replacement battery:

Install and replace the battery only by adults.

The battery is inside the controller.

If the controller is off, please check the batteries and contacts in the tag, and replace the battery if necessary. When replacing the battery, unscrew the controller from the front, gently pull out the LED, remove the old battery and insert a new battery